Installing Your New Unit; Basic Connection - JVC DR-MV1S Instructions Manual

INSTALLING YOUR NEW UNIT

16
EN

Basic Connection

Aerial connector
Back of TV
21-pin SCART connector
21-pin SCART cable
(provided)
Mains power cord
2
Back of unit
Mains outlet
It's essential that your unit be properly connected.
ATTENTION:
Your TV must have a 21-pin AV input connector (SCART) for the
connection to the unit.
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO
OPERATION CAN BE PERFORMED.
RF cable
TV aerial cable
(provided)
ANTENNA IN
L-1 IN/OUT
ANTENNA OUT
1
Make sure the package contains all of the accessories listed in
"SPECIFICATIONS" on page 95.
2
Place the unit on a stable, horizontal surface.
3
Connect the unit to a TV depending on the TV and cables you
use.
Basic Connection
8 To connect to a TV with AV input connectors —
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANTENNA IN connector on
the rear panel of the unit.
C Connect the ANTENNA OUT connector on the rear panel of the
unit and the TV's aerial connector with the provided RF cable.
D Connect the L-1 IN/OUT connector on the rear panel of the unit
and the TV's 21-pin SCART connector with a provided 21-pin
SCART cable.
● The L-1 IN/OUT connector accepts and delivers either a composite
signal (regular video signal), Y/C signal or RGB signal.
● Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to
the type of your TV's SCART connector.
● Select an appropriate option of "L-1 OUTPUT" as follows (
When your TV's SCART
connector accepts:
Composite video signals
Y/C signal (separated
luminance (brightness) and
chrominance (colour) signals)
RGB signal
8 Component Video Connection (DVD deck only)
To connect to TV's component video input connectors
A Perform A – C in "Basic Connection".
B Connect the unit's COMPONENT VIDEO OUT connectors to
the TV's component video input connectors.
C Connect the unit's AUDIO OUT connectors to the TV's AUDIO
input connectors.
● You can obtain high-quality component video pictures.
● If your TV is not stereo-capable, use the unit's AUDIO OUT
connectors to connect to an audio amplifier for Hi-Fi stereo sound
reproduction.
● By using the component video connection, you can view the images
in the progressive mode. For switching to the progressive mode, refer
to "Scan Mode Set" ( pg. 88).
4
Plug the end of the AC power cord into an AC outlet.
● "LOADING" blinks on the front display panel when the AC plug of the
power cord is connected into a mains outlet and no operation will be
done for approximately 50 seconds. This is not a malfunction.
After connection is completed, perform "Auto Set Up" on
page 17.
pg. 72):
Set "L-1 OUTPUT" to:
"SCART VIDEO"
"SCART S-VIDEO"
"SCART RGB"