System Connections - JVC DR-M10 Instructions Manual

SYSTEM CONNECTIONS EN 95
Connecting ToA Dolby Digital Decoder
or AnAmplifier W ith Built-in DTS
These instructions enable you to connect your unit to a Dolby Digital decoder or an amplifier with built-in DTS.
I
======
To DIGITAI_ AUDIO
input
_] olby Digital
decoder or
amplifier with
built-in DIS
DIGITAl OUT DIGITAL OUT
(COAXIAl) (OPTICAl)
Back of unit
L
Coaxial cable
(not supplied)
Optical cable
(not supplied)
Note for connection:
Remove the protection ca r)
from the optical cable.
Makeconnections.
Connect the unit and a Dolby Digital decoder or an
amplifier with built-in DTS using either an optional
optical cable or an optional coaxial cable.
NOTES:
• For Dolby Digital sound, set "DIGITAL AUDIO OUT" to
"DOLBY DIGITAL/PCM'. (_ pg. 97)
• For DTS sound, set "DIGI]AL AUDIO OUT" to "STREAM/
PCM'. (Z_" pg. 97)
CAUTIONS:
• This unit has a dynamic range of more than 110 dB with
regards to its Hi-Fi audio capability. It is recommended that
you check the maximum level if you are going to listen to the
Hi-Fi audio signals through a stereo amplifier. A sudden surge
in the input level to the speakers may damage them.
• Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the playback picture.