JVC DR-M10 Instructions Manual page 87

EN
87
Make connections.
Connect a camcorder or DV equipment to the DV IN
connector on the unit's front paneh
I_ Preparethe unitfor dubbing.
[] I.oad a DVD-RAM/RW/R
disc on the unit.
[]
Press CH +/- to set the
channel to "DV
DUBBING".
• The "DV DUBBING"
controller appears on the TV
screen.
• If "_o_l@" does not appear on
the "DV DUBBING"
controller, make sure the DV
equipment is connected
correctly.
[] Press _ to move _ to '_g !, then press
ENTER.
[] Press i',V repeatedly to select the desired sound track,
then press ENTER.
[] Press REC MODE repeatedly until the desired
recording speed appears. 1_-<_" p g. 58, "Recording
Speed")
I_1 Preparethe DV equipment f or dubbing.
locate the point from where you want to start dubbing,
then stop or pause playback by pressing the following
buttons on the Remote:
I_, I_1_, -_141, I, II
• To play back in slow speed (1/10 of the normal speed), press II
to pause playback, then press _1-_1or 1_1) ' _.
• To play back frame-by-frame, press II to pause playback, then
press II repeatedly. Each press of II advances a frame.
• To change the playback direction, press _1-_1or 1_11_.
L_e Start dubbing.
Press <" _" to move the arrow to then press
ENTER.
• Playback on the external DV equipment and recording on the
unit should start simultaneously.
• When the playback from the beginning is not possible, the
"DV DUBBING" controller cannot be used. Perform dubbing
without using the "DV DUBBING" controller. (_€" right
column)
• To pause dubbing, press "_- _ to move FS to _2_O _, then
press ENTER. Both the unit an(] the external DV equipment
pause dubbing. Pressing II on the unit also works the same
way.
• To clear the "DV DUBBING" controller from the TV screen,
press ON SCREEN.
I_ Stopdubbing.
Press • on the Remote.
• Both the unit an(] the external DV equipment stop dubbing.
NOTES:
• Dubbing copyright guarded programs is not possible.
• Original DV informations such as the recording (]ate an(] time
are not recorded.
• The superimposed indication during the operation or dubbing
is not recorded.
• Only DV format image can be dubbed; MPEG2 format image
cannot be dubbed.
Performing dubbing without using the "DV DUBBING"
controller
[] Press CH +/-to set the channel to'DV DUBBING".
[] Press REC MODE repeatedly until the desired recording
speed appears.
[] Start playback on the external DV equipment slightly before
the actual point from where you wish to start dubbing.
[] Press an(] hold •, then press I_ on the Remote, or press •
on the uniL
• Dubbing starts.
[] When the dubbing ends, press • on the unit, then stop
playback on the external DV equipment.