Timerrecording; Vcr Plus; Programing - JVC DR-M10 Instructions Manual

dO EN TIMER RECORDING
VCRPlus+ ® Timer
Programing
You can program this unit to timer-record as many as
8 programs.
With the VCR Plus+ system, timer programing is greatly
simplified because each TV program has a corresponding code
number which your unit is able to recognize.
You can use the Remote to enter the PlusCode number.
Before performing the VCR Plus+ Timer Programing:
• Turn on the unit.
• Turn on the TV and select the AV mode.
• Slide the TV/CABLE/DBS/DVD switch to DVD.
• Make sure that the unit's built-in clock is set
properly.
0_9_
X_
VCR Plus+
TV[_iD ....
T,_ TV [_)i _TA_bi3"i6_
VCR Plu_pR0r_._HECK REC LINKTIMER
PREVlOU_
SLOW- P_¥;_LEOT SLOW÷
REC _IODE LI_E'C _¢K
°0Z0,Z,Z
SETUP
0 0 0 _)
JVC
[NT[_
l
Loada disc.
[] Press A to open the disc tray.
[] Place a recordable disc on the disc tray.
• For details, refer to "Placing a Disc" (L_ _pg, 1 1).
[] Press A to close the disc tray.
F_I Access the VCRPlus+screen.
Press VCR Plus+.
I_1 Enterthe PlusCode n umber.
Press the number keys to
enter the PlusCode number
of a program you wish to
record, then press ENTER.
• [f you have made a mistake,
press X and input the correct
number before you press
ENTER.
• To dear all entered numbers at a time, press lB.
• If the number you entered is invalid, "PI USCODE NO. ERROR
CONFIRM PLUSCODE NO. THEN RETRY" appears on the TV
screen. Input a valid PlusCode number.
• If "GUIDE PROGRAM IS NOT SE] SELECT CHANNEl YOU
WANT TO RECORD" appears on the TV screen, set Guide
Channel Numbers (_-_" pg. 62) manually.
• When "PROGRAM FULL DELETE UNWANIED TIMER
PROGRAM" appears on the TV screen, you need to cancel
some of the reserved programs. (_ _ pg. 69)
L_e Check the programdata.
The PlusCode number you entered and the matching
timer-recording information are displayed on the TV
screen. Check if they are correct.
• To cancel this setting, press VCR Plus+ or RETURN.
IMPORTANT:
Make sure the channel position number you wish to re_ord is
displayed; if not, enter manually the channel position
number you wish to record.