JVC DR-M10 Instructions Manual page 59

Free RateFunction
To record the entire program, the unit automatically set the
appropriate recording speed depending on the combination of
the total time of the program to be recorded an(] either the
remaining disc space or the specified recording time (from 60
minutes to 480 minutes).
To record the entire program within the actual
remaining disc space
Select "FR (lUST)" in a recording speed selection procedure.
(_-_ pg. 61,65)
• Note that this function is available only for timer programing
recording.
To record the entire program by specifying the desired
recording time
Select "FR60-FR360", "FR420" or "FR480" in a re_ording speed
selection procedure. (_ pg. 57, 61, 65)
To record a 25-rain. long daily program five times just on
a same disc for example
Perform "VCR Plus+_Timer Programing" (_ pg. 60) procedure.
Be sure to set the recording speed to "FR125" and set Weekly/
Daily Rec Function to "MON FRI" in step [] to fit the total
recording time to the whole disc space.
A: 1st D:4th
B: 2nd E: 5th
C: 3 rd
When the same program is recorded in SP mode instead of in
"FR125", the 5th program cannot be recorded.
A: 1 st D:4th
B:2nd E: Blank
C:3rd (20 rain.)
NOTES:
• You can program this unit to timer-record, regardless of the
disc remaining time. When the disc remaining time is not
enough, recording may stop in the middle of a program. To
avoid this, make sure of the disc remaining time before setting
timer-programing.
(Example) If you programed to timer-record for 60 minutes in
SP mode on a 120-minute disc, the disc remaining time
would be 30 minutes in XP mode, 60 minutes in SP mode,
120 minutes in IP mode, 180 minutes in EP mode, and 240
minutes in FR480 mode. Timer-recording will not complete
beyond these remaining times.
• The maximunl recording time of FR (JUSI) mode is the same
as the recording time of FR480 mode. When timer-programing
a long program in FR (lUST) mode on a disc whose remaining
time is short, it is recommended checking the disc remaining
time in FR480 mode to see if the remaining time is enough for
the program.
• It may not be possible to [)lay back some discs recorded in
FR420 or FR480 mode on some other units.
• Even if more than one program are timer-programed in FR
(JUST) mode, only the first one is recorded.
• In order to ensure that the recording fits on the disc, this
feature may leave a slight non-recorded section at the end of
the disc.
• There may be some noise and sound disturbance at the point
on the disc where the unit switches the mode.
Second A udioRecording
This unit's built-in MTS decoder enables reception of
Multichannel TV Sound broadcast. lo record a SAP program
received, set "2ND AUDIO RECORD" to "ON". (_-_ pg. 98)
NOTES:
When the channel is changed on the unit;
• The "MONO" indicator appears on the screen for about 5
seconds if the program is a monoral broadcast.
• The "STEREO" indicator appears on the screen for about 5
seconds if the program is a stereo broadcast.
• Both "STEREO" an(] "SAP" indicators appear when a stere()
program is accompanied by SAP sound.
• Both "MONO" an(] "SAP" indicators appear when the main
audio on the monoral broadcast is accompanied by SAP
sound.