JVC DR-M10 Instructions Manual page 94

94 EN REMOTE (cont.)
DBSReceiver M ulti-Brand Remote
Control
Your Remote can operate the basic functions of your DBS (Direct
Broadcast Satellite) receiver set. In addition to JVC DBS
receivers, other manufacturer's DBS receivers can also be
control led.
Slide the TV/CABLE/DBS/DVD switch to CABLE/DBS. ]
Tv_DVD
_ tEED(ZD _)
vcPPlu_pR0_cH_ PEcuHK TIMER
PREvDus
SL_= PLaY;SElEcTsLO't_+
c_E R
PEc _0DELI_E' cHEcK
sETuP
_00®
dVC
0_9_
SET UP
TV/(BL/I)BS
(b!I
(H +/-
Set the DBSreceiverbrandcode.
Keep pressing SET UP down during step tl.
Enter your DBS receiver's [)rand code using the number
keys, then press ENTEr.
Press TV/CBL/DBS cb/I on the unit's Remote to turn on
the DBS receiver and try operations (_-_ step U).
• Once you have set the Remote to operate the DBS receiver,
you do not have to repeat this step until you replace your
Remote's batteries.
• Some brands of DBS receiver have more than one code. If the
DBS receiver does not function with one code, try entering
another.
_1 Operatethe DBSreceiver.
Press the corresponding button: TV/CBL/DBS G/I,
CH +/-, number keys.
• For some brands of DBS receiver, you must press ENTER after
having pressed the number keys.
• The number keys may not function with some DBS receivers.
BRAND NAME CODE
JVC (DISH Network) 51
ECHOSTAR (DISH Network) 51
SONY (DSS) 41
RCA (DSS) 40
NOTES:
• You must set the DBS receiver brand for your Remote and the
DBS receiver brand for your Controller (_-u" pg. 32) separately.
• It's not possible to operate a DBS receiver that is not equipped
with a remote sensor.
• It's not possible to set the Remote for both your DBS receiver
and a cable box at the same time. You can only set the Remote
to operate one of these units at a time.
IMPORTANT:
Although the supplied Remote unit is compatible with JVC DBS
receivers, as well as many other models, it may not work with
your DBS receiver, or in some instances, may have limited
function capability.