Edit To Or From Another Recorder - JVC DR-M10 Instructions Manual

Editro OrFrom
Another R ecorder
[]
[]
You call use your unit as the source player or as the
recording deck.
Slide the TV/CABLE/DBS/DVD switch to DVD.
Make connections.
]
TV receiver
AV mode
Player Your unit
S-Video cable I _Audio/video
[] When using your unit as the source player ...
... connect its AUDIO/VIDEO or AUDIO/S-VIDEO
OUTPUT connectors to the audio/video or audio/S-video
input connectors on another recorder.
[] When using your unit as the recording deck ...
... connect its AUDIO/VIDEO or AUDIO/S-VIDEO
INPUT connectors to tile audio/video or audio/S-video
output connectors on another recorder.
• If connecting a unit with an S-VIDEO input!output connector,
it is recommended to use an optional S-Video cable to
minimize picture degradation while editing.
_Set the inputmodeof recording deck.
With this video unit, press CH +/-to select "1.-1 " or "1-2"
depending on the connectors being used.
• When using S VIDEO connector, set "REAR AUX k-1" or
"REAR AUX [-2" to "S-VIDEO". i_-€ _ pg. 98)
Recorder
TV receiver
Your unit
_ _<_r_
S-Video cable
Audio/video _'_
cable
Another recorder
Player
Recorder
Jdio/video
ble
1
• When using VIDEO connector, set "REAR AUX I.-1" or "REAR
AUX [.-2" to "VIDEO". (_-u"pg. 98)
• When using another recorder as the recording deck, refer to its
instruction manual.
I_1 Set the recording speed.
Press REC MODE repeatedly until the desired recording
speed appears.
L_e Start the source player.
Engage the Play mode of the source player.
_ Start the recording deck.
Engage the Record mode of the recording deck.
_J Stopdubbing.
Stop recording on the recording deck, then stop playback
on the source player.
NOTES:
• All necessary cables can be obtained from your dealer.
• When you use this unit as the source [)layer for editing, be sure
to set "SUPERIMPOSE" to "OFF" before starting. (_-_"pg. 99)