Manual Timer Programing - JVC DR-M10 Instructions Manual

d_ EN TIMER RECORDING (cont.)
Manual Timer
Programing
You can program this unit to timer-record as many as
8 programs.
If you do not know the PlusCode number for the program you
wish to record, use the following procedure to set your unit to
timer-record the program.
Before performing Manual Timer Programing:
• Turn on the unit.
• Turn on the TV and select the AV mode.
• Slide the TV/CABLE/DBS/DVD switch to DVD.
• Make sure that the unit's built-in clock is set
properly.
0_9_
TV_DVD
T0PMEN0 r_Vl_'ll0N
r_ENU nET0_N
PREVJ0US
(ZE3
SLOW= P_¥;SELECTSLOW÷
REC _0DELI_E'C HECK
°0ZoN%Z
SETOP
OOO_
JVC
l
Loada disc.
[] Press A to open the disc tray.
[] Place a recordable disc on the disc tray.
• For details, refer to "Placing a Disc" (L_ _pg. 1 1).
[] Press A to close the disc tray.
F_ Access Program Check screen.
Press PROG/CHECK.
• When "PROGRAM FULL
DELETE UNWANTED TIMER
PROGRAM" appears on the
TV screen, you nee(] to cancel
some of the reserved
programs. ?-€_ pg. 69)
I_1 Access the programscreen.
Press/\_ repeatedly to
select "NEW TIMER
PROGRAM", then press
ENTER.
L_e Enterthe recording date.
Press/\_ repeatedly to set the desired date.
• The current (]ate appears on the TV screen. The date you enter
appears in its [)lace.
_ Enterthe recording start time.
Press <" b" to select "START", then press/\_ repeatedly
to set the desired start time.
• Each press of/\_ advances/goes back the start time in l-rain.
increments.
• To advancdgo back the start time in 30-rain. increments, press
an(] hold/\_.