Sort The Copy Groups Panel - HP StorageWorks P9000 Reference Manual

◦ When f is specified, neither Approx. Matching % nor CTDelta is displayed on the Copy Group Status Summary
panel.
◦ When f is specified, neither Match Rate% nor CT Delta DDD HH:MM:SS is displayed on the Copy Group Pair Status
panel.
◦ When f is specified, EXCTG registration error checking is not performed on copy groups for which EXCTG ID is
specified. If copy pair has not been registered or is being registered in EXCTG, the PENDING status is reported
when q is specified in AC, while DUPLEX status might be reported when f is specified in AC.
◦ When f is specified, the CAJ copy pair status at the time the BC copy pair is suspended is not checked for an BC
copy group for which a CAJ ATTIME suspend time has been set.
3 If you specify f for a CA copy group with a consistency group ID, use a route list that includes the storage system
where the CA copy group is defined. If f is specified and a route list is used that does not include the storage system
where the CA group is defined, the counts displayed for each copy pair status on the Copy Group Status Summary
and Copy Group Storage System Summary panels, and the copy pair statuses displayed on the Copy Group Pair
Status panel will not be correct.
4 xx is a return code from each command.
5 The status is the status (DUPLEX, SUSPEND, SIMPLEX, SUSPVS, or HOLD) of the monitored copy group.
The YKMAKE, YKSUSPND, YKRESYNC, YKDELETE, and YKRECVER commands involve changing
copy pair statuses. Status transition takes time, so be sure to use the YKQUERY command to check
that the transition is complete.
NOTE: Status displays the execution result of the action specified for AC. If you specify q for AC,
the YKQUERY command is executed and the Copy Group Status Summary panel is displayed. After
you finish operations, such as executing the YKMAKE command for each copy pair in the Copy
Group Pair Status panel, and then return to the Manage Copy Groups panel, Status displays the
execution result of the YKQUERY command.
You can use the LOCATE, SELECT, and SORT commands in the Manage Copy Groups panel. For
details about how to use each command, see
You can specify the following fields for a sort key of the SORT command:
Name of field
CGID
STATUS
You can specify the following fields for a condition of the SELECT command:
Name of field
CGID
STATUS
If you omit the field name, CGID will be set as a default value.

Sort the Copy Groups Panel

If you press the F6=Sort key in the Manage Copy Groups panel, the Sort the Copy Groups panel
appears.
Figure 99 (page 119)
1 18 ISPF Panels
Sorted by
Copy group ID
Result of action execution
Value in field
Copy group ID
Result of action execution
shows the Sort the Copy Groups panel.
"Command Line Commands" (page
Direction
Ascending
Ascending
Type
Character string
Character string
11).