Toner Cartridge Ejector - Lexmark Optra C Service Manual

5045-001

Toner Cartridge Ejector

See Assembly 12-1.
For cover removals, see
1. Remove the two screws from the operator panel and remove the
operator panel.
2. Remove the front door.
3. Remove the top cover.
4. Remove the left cover.
5. Remove one of the toner cartridges.
6. Remove the screw and the upper right hand front panel.
7. Remove the four screws and the left front panel.
8. At the left, rear of the ejector assembly there is a latch which
goes into the bottom frame. Push this latch toward the center of
the machine to release it.
9. Push the ejector to the rear and lift up.
10. Disconnect the connector (either at the ejector board or on the
rear frame of the machine).
11. Slide the ejector out of the front of the machine. Do not damage
the switch on the ejection sensing PCB located directly below
the front of the ejector.
Note: When reinstalling, line the handle up with the handle guide
before pressing the latches in place.
4-62
"Cover Removals" on page 4-8.