Diagnostic Aids; Basic Engine Test - Lexmark Optra C Service Manual

5045-001

3. Diagnostic Aids

This printer has three different methods of running diagnostics.
The printer can run internal diagnostics tests. These tests are in the
same format as the other Optra models and are described in this
chapter. These tests work in conjunction with the
Test (POST)" on page
The printer may be tested without the video controller board. The
basic engine test will isolate a failure to either the engine or the
video controller board.
If the printer is configured with the optional sheet feeder or any of the
internal options, remove the option(s) and run one of the three
diagnostic methods to determine where the problem is located.
There are six internal engine tests accessible by the
Adjustment Panel" on page
video controller board.

Basic Engine Test

This test eliminates the video controller board as the source of a
malfunction.
1. Turn the printer off.
2. Disconnect the controller board by sliding it to the rear 1 inch.
The display will not function now.
3. Remove the small access cover on the left side cover.
4. To prevent a short or damage to the machine, use an insulated
jumper and jumper pin 8 to pin 3 of connector J109, connecting
pin 8 first. See
(Graphic)" on page
5. Turn the printer on, and observe the POST sequence
On Self Test (POST)" on page
POST, the basic engine is functioning properly.
3-1
2-8.
3-12. The tests run with or without the
"DC Controller Board Connector Locations
5-18.
"Power-On Self
2-8. If the printer completes
"Density
"Power-