Lexmark Optra C Service Manual page 38

5045-001
Code Symptom
41 Waste Bottle Full
Check for:
• Full bottle
• Improper installation
• Missing bottle
• Broken interlock
• Toner on window of bottle (Use a clean, dry rag to clean the
window. Do not use finger.)
42 Oil Bottle Empty/Missing
Check to ensure the bottle is not empty. If the bottle has oil,
remove the fuser and verify the float ball in the oil bottle case is
following the level of the oil. Check the operation of the oil sensor
PCB in the machine, (it is not in the fuser).
43 Photoconductor Unit Missing
Ensure that the photoconductor unit is completely seated in the
machine. Check the continuity from J1004-5 on the HVPS to the
spring that contacts the pad on the rear of the photoconductor.
There is a resistor of approximately ± 9K ohms in this line.
44 Fuser Life Exhausted
Remove the fuser from the printer. Remove the yellow cover from
the top of the fuser and verify that the cleaning web is exhausted.
A notch at the life limit of the web allows an arm to drop, which
blocks a sensor located on the printer, (not the fuser) near the exit
drive mechanism. If the web is exhausted, drain the fuser oil and
replace the fuser. If the arm has prematurely dropped, (or if the
customer has pushed it down), reset the arm on top of the web
and reinstall the fuser.
Note: Fuser replacement is the responsibility of the customer.
45 Paper Feed Mechanism Missing
Either the paper feed mechanism has not been securely latched
into the machine or there is a problem with the self docking
connector.
2-6