Maintaining the printer
The accuracy of the estimated number of remaining pages may decrease when the actual printing consumption
is different from the historical printing consumption. Consider the variable level of accuracy before purchasing
or replacing supplies based on the estimate. Until an adequate print history is obtained on the printer, the
estimated cartridge yield is based on approximately 5% coverage per page.
Ordering a toner cartridge
Notes:
•
The estimated cartridge yield is based on approximately 5% coverage per page.
•
Extremely low print coverage for extended periods of time may negatively affect actual yield.
Part name
Toner Cartridge
Ordering an imaging unit
Extremely low print coverage for extended periods of time may cause imaging unit parts to fail prior to
exhaustion of toner.
For more information on replacing the imaging unit, see the instruction sheet that came with the supply.
Part name
Imaging unit
Ordering staple cartridges
Item
Staple cartridges
Ordering a maintenance kit
To identify the supported fuser type, view the label on the fuser. Do either of the following:
•
Remove the toner cartridge and imaging unit. The two-digit fuser type code (such as 00 or 01) can be seen
on the front of the fuser.
Warning—Potential Damage: Do not expose the imaging unit to direct light for more than 10 minutes.
Extended exposure to light may cause print quality problems.
•
Pull down the printer rear door. The two-digit fuser type code (such as 00 or 01) can be seen on the rear of
the fuser.
Notes:
•
Using certain types of paper may require more frequent replacement of the maintenance kit.
•
The separator roller, fuser, pick roller assembly, and transfer roller are all included in the maintenance kit
and can be individually ordered and replaced if necessary.
•
For more information on replacing the parts included in the maintenance kit, see the instruction sheet
that came with the part.
Part number
24B6015
Part number
24B6025
Part number
25A0013
141