Fuser Cleaner Assembly - Lexmark Optra C Service Manual

5045-001

Fuser Cleaner Assembly

See Assembly 32-8.
Note: Replace this assembly only if it breaks or malfunctions. When
the machine has printed 60,000 pages or less, depending upon the
ratio of paper to transparence, the fuser and other items must be
replaced in order to maintain maximum print quality.
1. Remove the fuser assembly.
2. Place the fuser on a flat surface.
Note: Do not tilt the fuser. It contains oil that can spill.
3. Remove the two screws from the protective cover and remove
the cover.
4. Remove the four screws from the top of the fuser cleaner
assembly (two on each side).
5. Remove the two screws from the front and one screw from the
rear of the fuser cleaner assembly.
6. Remove the screw from the rear knob and remove the knob.
7. Remove the screw from the shield surrounding the knob and
remove the shield.
8. Remove the two screws from the heater/terminal block cover
located at the rear of the fuser and remove the cover.
9. Remove the two screws from the terminal block bracket.
10. Take the fuser lamp cables out of the cable holder located at the
top right of the fuser.
11. Remove the two screws from the delivery guide located at the
top right of the fuser and remove the guide.
12. Lift the fuser cleaner assembly off the fuser.
Repair Information 4-33