Transfer Drum Sheet - Lexmark Optra C Service Manual

5045-001

Transfer Drum Sheet

See Assembly 28-8.
1. Remove the transfer drum and holder assembly.
2. Remove the two springs from the attraction roller holder.
3. Remove the two springs from the discharge roller holder.
4. Remove the two extension springs holding the one end of the
transfer drum sheet to the transfer drum.
5. Rotate the drum while peeling the sheet off the drum surface.
6. Remove the two screws from the gripper springs and remove
the springs and holders.
7. Remove the sheet from the drum.
8. Use alcohol to clean the surface where the two-sided tape was
applied to the gripper assembly.
9. Use cotton gloves to handle the replacement transfer sheet.
10. When mounting the transfer sheet, make sure the holes in the
sheet mount securely in the 3 designated projections of the
gripper assembly.
11. Make sure the transfer sheet does not slack or float in the center
or at the edges.
4-54