Lexmark Optra C Service Manual page 192

5045-001
Paper Feeder Circuit Board
See Assembly 36-6.
1. Remove the rear cover.
2. Remove the six screws and the gear cover.
3. Disconnect the three connectors under the gear cover.
4. Remove the three mounting screws and carefully slide the
board and its mount out enough to disconnect the three
connectors on the board.
5. Remove the four mounting screws to remove the board from its
mount.
Note: The Open/Close Door must be open when reinstalling the
board and the mount, to prevent interference with the switch rod and
switch. Check the side registration and switch setting on the new
board with the old board.
Paper Feed Roller (Unit 2)
See Assembly 35-7.
1. Remove the front pickup unit.
2. Remove the two E-clips, the two bearings and the gear.
3. Remove the feed roller.
Paper Pickup Motor
See Assembly 35-19.
1. Remove the front pickup unit.
2. Remove the two screws and the motor.
4-66