5045-001
Density Adjustment Panel
See Assembly 8-27.
For cover removals, see
1. Remove the top cover.
2. Remove the left side cover and the rear cover.
3. Disconnect the wire cable from the density adjustment panel.
4. Remove the screw that retains the fan grill and panel bezel and
remove the bezel.
5. Remove the two panel mounting screws and remove the panel.
Density Sensor
See Assembly 30-6.
1. Open the top cover and disconnect the link.
2. Position the sensor so it is facing up and disconnect the springs
at the top end.
3. Lower the sensor to unlock the cable connector at the sensor
end and disconnect the ribbon cable.
4. Remove the E-clip and slide the sensor assembly forward to
remove it from the machine.
"Cover Removals" on page
4-8.
Repair Information 4-23