5045-001
Drum Lift Assembly
Note: This assembly lifts the transfer drum into the photoconductor.
See Assembly 19-1.
For cover removals, see
1. Remove the transfer drum assembly.
2. Remove the top cover.
3. Remove the left side cover and the rear cover.
4. Remove the EMC shield from the rear of the machine.
5. Open the multipurpose paper pickup door.
6. Release the two green cassette latches and slide the tray out as
far as possible.
7. Remove the connector cover (Asm 8-24) and disconnect the
connector.
8. Remove the LVPS.
9. Disconnect connector (J2014) from the mechanical controller
PCB.
10. Remove the four mounting screws to the drive gear solenoid
assembly and remove the assembly. Disconnect the remaining
2-pin connector from the frame.
11. Remove the two screws from the drum drive assembly and
remove the assembly.
4-28
"Cover Removals" on page
4-8.