Drive Gear Solenoid Assembly - Lexmark Optra C Service Manual

5045-001

Drive Gear Solenoid Assembly

See Assembly 13.
For cover removals, see
1. Remove the top cover.
2. Remove the left side cover and the rear cover.
3. Remove the rear EMC shield.
4. Open the multipurpose paper pickup door.
5. Release the two green cassette latches and slide the tray out as
far as possible.
6. Remove the connector cover (see Assembly 8-24) and
disconnect the connector.
7. Remove the LVPS.
8. Disconnect the 2 pin connector and the J2014 connector from
the mechanical controller PCB.
9. Remove the four mounting screws
10. Remove the drive gear solenoid assembly.
Note: When reinstalling this assembly, turn the main drive motor
(M2) counterclockwise after installing the 4 solenoid assembly
mounting screws, this ensures that all 4 solenoid have latched up
their corresponding gears. Turn M2 until all 4 gears are latched up.
4-26
"Cover Removals" on page 4-8.