5045-001
Rotary Manual Feed Assembly
See Assembly 15-1.
For cover removals, see
1. Open the top cover and the front cover.
2. Remove the left side cover and rear cover.
3. Remove the EMC shield from the rear of the machine.
4. Disconnect J1004 from the HVPS.
5. Remove the lower fan and ducts.
6. Remove the mechanical controller PCB.
7. Remove the 3 screws and work the mechanical controller PCB
mounting base up and out of the machine.
8. Remove the set screw and knob from rotator.
9. Remove the 4 rotator assembly mounting screws and pull the
assembly out the back of the machine.
Rear Cooling Fan
See Assembly 7-7 and 7-8.
For cover removals, see
1. Remove the top cover.
2. Remove the left side cover and the rear cover.
3. Remover the EMC shield form the rear of the machine.
4. Disconnect the fan connector at the mechanical controller PCB.
5. Release the 2 latches on the duct work that secures the fan and
pull straight out.
"Cover Removals" on page
"Cover Removals" on page
4-8.
4-8.
Repair Information 4-49