Transfer Drum Cleaning Drive Assembly - Lexmark Optra C Service Manual

5045-001

Transfer Drum Cleaning Drive Assembly

See Assembly 17-1.
For cover removals, see
1. Remove the top cover.
2. Remove the left side cover and the rear cover.
3. Remove the EMC shield from the rear of the machine.
4. Open the multipurpose paper pickup door.
5. Release the two green cassette latches and slide the tray out as
far as possible.
6. Remove the connector cover (Asm 8-24) and disconnect the
connector.
7. Remove the LVPS.
8. Disconnect connector (J2014) from the mechanical controller
PCB.
9. Remove the four mounting screws from the drive gear solenoid
assembly and remove the assembly. Disconnect the remaining
2-pin connector from the frame.
10. Remove the four screws from the main drive motor and board
assembly and remove the assembly.
11. Remove the three screws from the transfer drum drive assembly
and remove the assembly.
Note: One of the screws is accessed through a hole in the printer
drive assembly.
"Cover Removals" on page 4-8.
Repair Information 4-61