Lvps / Hvps To Controller Card Cable Removal; Manual Feed Clutch Assembly Removal; Operator Panel Removal - Lexmark E330 Service Manual

LVPS / HVPS to controller card cable removal

(See "Electronics" on page
1. Remove the LVPS/HVPS card. See
assembly removal" on page 4-10
2. Remove the controller card cover. See
removal" on page 4-4
3. Unplug the cable at J7 and extract the cable.
Note: The card may not have to be completely removed to
disconnect the cable.

Manual feed clutch assembly removal

(See "Frame" on page
1. Remove the left side cover.
2. Place the printer on its right side. Protect the cover from being
marred.
3. Remove the four screws in the gear train metal cover.
4. Remove the clip from the shaft of the pick up clutch assembly.
5. Remove the screw and lever (pawl).
6. Remove the clutch assembly. If the pieces come apart, they can
be easily reassembled if necessary.

Operator panel removal

(See "Electronics" on page
1. Open access door.
2. Open the right cover.
3. Remove the controller card cover.
4. Unplug the operator panel from the controller card at J16.
5. Remove two screws at the front top and bottom of the operator
panel.
6. Remove the operator panel.
7-4.)
for more information.
7-6.)
7-4.)
"LVPS / HVPS card
for more information.
"Controller card
Repair information
4505
4-11