Exit Drive Belt Removal; Exit Roller Removal; Feed Arm Assembly Removal - Lexmark Optra Color 40 Service Manual

4092-010

Exit Drive Belt Removal

1. Remove the front cover.
2. Remove the rear cover.
3. Remove the carrier frame assembly.
4. Remove the paper load door and manual insert tray.
5. Remove the small feed roll shaft.
6. Remove the two screws from the star roller assembly and
remove the assembly.
7. Unlatch the left side of the exit roller shaft and work the belt off
the exit roller pulley.
8. Pull up the four clips securing the mid frame to the large feed
roll and work the mid frame out of both side frames.
9. Spread the right side frame apart far enough to allow removal of
the exit drive belt.

Exit Roller Removal

1. Remove the front cover.
2. Remove the two screws from the star roller assembly and
remove the assembly.
3. Unlatch the left side of the exit roller and remove the exit drive
belt from the exit roller pulley.
4. Remove the exit roller.

Feed Arm Assembly Removal

1. Remove the front cover.
2. Remove the rear cover.
3. Remove the C-clip from the feed arm and remove the assembly.
4-8
Service Manual