Table of Contents
Advertisement
General Configuration Screen
Table 5-2 General Configuration Screen Field Descriptions (Continued)
Use this field...
Agg Mode
(Toggle)
5.2.1
Setting the IP Address
NOTE: If the 6C105 or 6C107 chassis has been assigned an IP address, it is not
necessary to assign an IP address to the switch module. All installed modules have the
same IP address as the chassis. If a separate IP address for the switch module is
needed, proceed as follows.
To set the IP address, perform the following steps:
1. Use the arrow keys to highlight the IP Address field.
2. Enter the IP address into this field using Dotted Decimal Notation (DDN) format.
For example: nnn.nnn.nnn.nnn
3. Press ENTER. If the IP address is a valid format, the cursor returns to the beginning of the IP
address field. If the entry is not valid, the screen displays the message "INVALID IP ADDRESS
OR FORMAT ENTERED". Local Management does not alter the current value and refreshes
the IP address field with the previous value.
4. Use the arrow keys to highlight the SAVE command, then press ENTER. The warning screen
shown in
Figure 5-3
5-8
Module Configuration Menu Screens
To...
Select the trunking method that the switch will use to create a trunk
consisting of a group of ports to increase the bandwidth between
switches.
You can select either the Enterasys Networks' SmartTrunking
(Huntgroup) or the IEEE 802.3ad protocol. This field toggles between
HUNTGROUP and IEEE8023ad. The default is HUNTGROUP.
NOTE: When the Agg Mode is set to 8023ad, the Port
Configuration menu item SMARTTRUNK CONFIGURATION
is replaced with LINK AGGREGATION MENU. This menu
screen provides access to other screens to display Port,
Aggregator and System information, view and configure all
the port-related LACP parameters, and display a summary of
all the available aggregators and other related information.
For more information, refer to
displays.
Section
6.1.
Advertisement
Table of Contents
