Built-In Commands - Enterasys 6E2xx Local Management User’s Manual

Refer to Table 12-1
Table 12-1 Built-in Commands
alias
bridge
ev
loopback_detect
MAC_lock trap
disable
passiveStp
reset
show mac
stpPointToPointMAC
stpStandby
traceroute
1. The atm_stp_state command only displays when an HSIM or VHSIM is installed that supports ATM, such as the
HSIM-A6DP or VHSIM2-A6DP.
2. The gigabit_port_mode command only displays when a gigabit interface module is installed.
•
Special Commands – Allow the user to exit from Network Tools. The commands are done, quit,
and exit.
NOTES: The conventions used in describing the commands in Network Tools are as
follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by the user is shown in
bold font
.
To abort the output or interrupt a process, press the CONTROL key and c key
simultaneously, designated as ^C here.
for a list of the commands.
arp
cdp
gigabit_port_mode
MAC_lock disable
MAC_lock trap
enable
ping
sat_size
soft_reset
stpLegacyPathCost
telnet
vrrpPort
arp_learn
defroute
2
lg_frame_admin
MAC_lock enable
netstat
radius
suppress_topology_
traps
stpEdgePort
stpPort
timed_reset
Network Tools
atm_stp_state
dynamic_egress
link_trap
MAC_lock status
non_bridge_if_num
rate_limit_mode
show
stpForceVersion
stpRealTimeMsgAge
timed_soft_reset
Network Tools Screens
1
12-3