Built-In Commands - Enterasys 6E2xx Local Management User’s Manual

Built-in Commands

The commands are presented in the following format:
command
Description:
Syntax:
Options:
Example:
12.2 BUILT-IN COMMANDS
The built-in commands listed in this section activate functions on the LM managed device or
devices being accessed through Network Tools.
alias
Description:
Syntax:
Options:
12-4 Network Tools Screens
Briefly describes the command and its uses.
Shows the required command format. It indicates where arguments, if any,
must be specified.
Lists any additional fields in the appropriate format that may be added to the
command.
Shows an example of the command.
Used to enable and disable snooping (per Port). Also clears retrieval and
clearing of stats along with listing and setting of various configuration items.
alias [enable | disable | status] [ALL | port # | port range, i.e., 1-5]
alias [stats]
alias [clear_stats]
alias [fwd_list]
alias [fwd_set] [rate | burst] [value]
enable – Enables alias snooping on specific port or port range.
disable – Disables alias snooping on specified ports or port range
status – Displays the current alias snooping state (enabled or disabled) on a
port or port range.
stats – Displays current alias snooping state statistics.
clear_stats – Clears all alias snooping statistics.
fwd_list – Lists current configuration settings including max frame size, max
host queue, max PPS, and max burst.
fwd_set – Allows setting of max PPS and/or max burst configuration settings.