Access Control List Screen - Enterasys 6E2xx Local Management User’s Manual

7. Use the arrow keys to highlight the SAVE command and press ENTER. The message "SAVED
OK" displays on the screen.
NOTE: Exiting without saving causes a "NOT SAVED?" message to display above the
SAVE command. Edits are lost if they are not saved before exiting.
The designated workstations will now receive traps from the switch module as long as the
communication path to the designated workstations are not inhibited (for example, by subnets or
VLANs).
5.6

ACCESS CONTROL LIST SCREEN

When to Use
To view, enable, or disable the Access Control List (ACL) and configure address filtering to
provide additional security. You can limit user access to the switch module according to their
IP addresses. Up to 16 single IP addresses and/or range of addresses can be configured.
To manage an ACL enabled switch module, the management station must be a member of the ACL
and authenticated according to traditional SNMP rules.
NOTE: Clearing NVRAM will remove all IP address entries and return the access
control state to DISABLED.
When the ACL is disabled, host access is not restricted.
How to Access
Use the arrow keys to highlight the ACCESS CONTROL LIST menu item on the SNMP
Configuration Menu screen, and press ENTER. The Access Control List screen,
displays.
Access Control List Screen
Module Configuration Menu Screens
Figure 5-10,
5-25