Removing The Control-Panel Assembly - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

4
Retention tab
5
Virtual media key connector
Step 9. Reinstall any adapters that you removed earlier.
Step 10. Rotate the rear adapter retention bracket to the closed (locked) position.
Step 11. Reinstall the side cover (see "Installing the side cover" on page 252).
Step 12. Lock the side cover.
Step 13. Reconnect the external cables and power cords; then, turn on the attached devices and turn on
the server.

Removing the control-panel assembly

To remove the control-panel assembly, complete the following steps.
Step 1. Read the safety information (see Chapter 2 "Safety information" on page 3).
Step 2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
Step 3. Unlock and remove the side cover (see "Removing the side cover" on page 146).
Step 4.
Open the bezel. Place your finger on the pull point area on the left side of the bezel door and
rotate it away from the server.
Step 5. Rotate the power-supply cage assembly out of the chassis. Lift up the power-supply cage handle
and pull the power-supply cage assembly all the way up until the retainer latch locks the cage in
place on the chassis.
246
ThinkServer TD200 Hardware Maintenance Manual