Software; Easystartup; Easymanage - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

Table 1. Features and specifications (continued)
Up to eight expansion slots
(depending on the model):
• Six expansion slots on the system
board
– Four PCI Express Gen2 x8 slots
(two x8 links and two x4 link)
– One PCI Express Gen2 x16 slot
(x8 link)
– One PCI 32-bit/33 MHz slot
• One PCI Express Gen1 x8 (x4) slot
on the one-slot extender card
• Two PCI-X 32-bit/64-bit
133/100/66/ MHz slots on the
two-slot extender card

Software

Lenovo provides software to help get your sever up and running.

EasyStartup

The EasyStartup program simplifies the process of configuring your RAID controllers and installing supported
®Windows and Linux operating systems and device drivers on your server. The EasyStartup program is
provided with your server on DVD. The DVD is self starting (bootable). The User Guide for the EasyStartup
program is on the DVD and can be accessed directly from the program's interface. For additional information,
see "Using the EasyStartup DVD" on page 302.

EasyManage

The ThinkServer EasyManage Core server provides centralized hardware and software inventory
management and secure automated system management through a centralized console. The ThinkServer
Video controller (integrated into
IMM):
• Matrox G200eV video graphics
controller integrated on the system
board
– Compatible with SVGA and VGA
– 8 MB DDR2 SDRAM video
memory controller
Note: The maximum video resolution
is 1600 x 1200 at 85 MHz
Diagnostic LEDs:
• Fan
• Microprocessor
• Memory
• Power supply
• Voltage regulator module (VRM)
• PCI
• Battery
• IMM heartbeat
• Enclosure manager heartbeat
Electrical input:
• Sine-wave input (50 or 60 Hz)
required
• Input voltage and frequency ranges
automatically selected
• Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
• Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
• Input kilovolt-amperes (kVA)
approximately:
– Minimum: 0.21 kVA (all models)
– Maximum: 0.82 kVA
Notes:
1. Power consumption and heat
output vary depending on the
number and type of optional
features installed and the
power-management optional
features in use.
2. These levels were measured
in controlled acoustical
environments according to
the procedures specified by the
American National Standards
Institute (ANSI) S12.10 and
ISO 7779 and are reported in
accordance with ISO 9296. Actual
sound-pressure levels in a given
location might exceed the average
values stated because of room
reflections and other nearby
noise sources. The declared
sound-power levels indicate an
upper limit, below which a large
number of computers will operate.
.
Chapter 3 General information
13