Installing The Battery - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

4
Front panel connector
5
Reserved
6
USB internal tape drive signal
cable connector
7
Reserved
8
Front USB connector
9
Reserved
10
Hard disk drive backplane
configuration signal cable
connector
11
Hard disk drive backplane
power cable connector
Step 8. Remove the battery:
a. Use a finger to push the battery horizontally out of its socket, pushing it away from the
socket 1
b. Lift and remove the battery from the socket
Step 9. Dispose of the battery as required by local ordinances or regulations.

Installing the battery

The following notes describe information that you must consider when replacing the battery in the server.
• After you replace the battery, you must reconfigure the server and reset the system date and time.
• The lithium battery must be handled correctly to avoid possible danger. If you replace the battery, you
must adhere to the following instructions.
• You must replace the battery with a lithium battery of the same type from the same manufacturer.
• To avoid possible danger, read and follow the following safety statement.
Statement 2
CAUTION:
When replacing the lithium battery, use only a battery recommended by the manufacturer. If your
system has a module containing a lithium battery, replace it only with the same module type made by
the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or
disposed of. Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
.
15
SATA 0 (optical drive connector
16
SATA 1
17
Reserved
18
Battery
19
PCI extender card connector
20
Microprocessor 1
21
Virtual media key connector
22
Power 2
2 .
Chapter 7
.
Installing and replacing FRUs
159