Removing The Media Cage (Also Called Lightpath Lcd Operation Panel Assembly) - Lenovo System x3650 M5 Installation And Service Manual

Figure 113. Fan installation
Note: Make sure that the newly-installed fan aligns horizontally with other correctly-seated fans for
proper installation.
Step 6. Replace the top cover (see "Replacing the top cover" on page 164).
Step 7. Slide the server into the rack.
Removing the media cage (also called lightpath LCD operation panel
assembly)
Use this information to remove the media cage (also called lightpath LCD operation panel assembly).
To remove the media cage, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page
305.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the top cover (see "Removing the top cover" on page 162).
Step 4. Disconnect the front USB, DVD drive and operator information panel/LCD panel cables from the
system board. Remember the relevant cable routing.
Note: To disconnect the operator information/LCD panel cable, press evenly on the connector
first; then, pull the cable out.
194
Lenovo System x3650 M5 Installation and Service Guide
Fan 6
Hot-swap
fan error LED
Fan 5
Fan 4
Fan 3
Fan 2
Fan 1