1
Signal cables for drives 4-7 (backplane labeled A1)
2
Adapter connector for drives 4-7 signal cable
3
Signal cable for drives 0-3 (backplane labeled AD)
4
Adapter connector for drives 0-3 signal cable
Connect the single end of the power cable to the Hard disk drive backplane power connector
(labeled A) on the system board and connect the split end of the power cable to the connectors
on the backplane as shown in the illustration.
1
Power connector (labeled A)
2
Power cable
3
Backplane power connectors
• For the four drive-bay, 3.5 inch server model, connect the signal cable as shown in the following
illustration:
236
ThinkServer TD200 Hardware Maintenance Manual