Table of Contents
Advertisement
9. Slide the I/O drawer backplane assembly to the rear and remove the assembly.
10. Remove the RIO card assembly as described in "RIO Card Assembly" on
Replacement
1. Replace in reverse order.
2. Set the drawer type using the service processor menus.
3. Check firmware level by checking the version on the title of the service processor
4. The service processor settings have been set to default values. These settings must
|
|
448
Service Guide
page 449.
a. From the SP Main Menu, select System Information Menu (option 3).
b. Select Power Control Network Utilities Menu (option 9).
c. Select Change I/O Type (option 3).
d. For the I/O drawer address (drawer number), type:
v 1 for a primary drawer.
v 2 for the secondary drawer.
e. For the I/O type, type:
v 85 for the primary I/O drawer.
v 84 for the secondary drawer.
main menu. If the firmware level is not at the correct level, proceed as follows:
v Reprogram all system EPROMs using the Service Processor Setup Menu and
selecting Reprogram Flash EPROM Menu option (7).
be restored to their original settings if they were not previously set to default values.
v Manually reset all settings.
v If the service processor settings had previously been saved, the settings may be
restored using the procedure in "Saving and Restoring Service Processor
Settings" on page 370.
v Reset the bootlist using the SMS menus.
v Reset the time-of-day clock using SMIT.
Advertisement
Table of Contents
