Chapter 7. Removal And Replacement Procedures - IBM RS/6000 7046 Service Manual

All manuals and user guides at all-guides.com

Chapter 7. Removal and Replacement Procedures

Before performing any of the removal or replacement procedures in this chapter,
read the following notice.
DANGER
An electrical outlet that is not correctly wired could place hazardous
voltage on metal parts of the system or the devices that attach to the
system. It is the responsibility of the customer to ensure that the outlet
is correctly wired and grounded to prevent an electrical shock.
Before installing or removing signal cables, ensure that the power
cables for the server and all attached devices are unplugged.
When adding or removing any additional devices to or from the system,
ensure that the power cables for those devices are unplugged before
the signal cables are connected. You must disconnect all power cables
from the existing system before opening the server to add a device.
Use one hand, when possible, to connect or disconnect signal cables
to prevent a possible shock from touching two surfaces with different
electrical potentials.
During an electrical storm, do not connect cables for display stations,
printers, telephones, or station protectors for communications lines.
CAUTION:
This product is equipped with a 3-wire power cable and plug for the user's
safety. Use this power cable in conjunction with a properly grounded electrical
outlet to avoid electrical shock.
Chapter 7. Removal and Replacement Procedures
7-1