Table of Contents
Advertisement
Table 5. Firmware Error Codes. (continued)
212
Service Guide
Error Code Description
2B2x xx11 Processor is manually disabled
2B20 0022 Processor is deconfigured by the
system
2B2x xx31 Processor is failing POST
2B20 0031 Processor is failing POST or is
manually disabled.
2B20 0042 Unknown processor card
2BA00000 Service processor POST failure
2BA0 0012 Service processor reports self test
failure
2BA0 0013 Service processor reports bad
NVRAM CRC
2BA0 0017 Service processor reports bad or low
battery.
2BA0 0041 Service processor VPD is corrupted.
2BA0 0080 Service processor reports memory
riser card VPD module not present.
2BA0 0081 VPD data corrupted for memory riser
card in slot 0.
2BA0 0083 VPD data corrupted for memory riser
card in slot 1.
Action/
Possible Failing FRU
Use the service processor menus to
re-enable the processor and reboot
the system
1. Replace the processor card.
Location: U1.1-P1-C1
2. CEC backplane
Location: U1.1-P1
Replace the processor card.
Location: U1.1-P1-C1
1. If the processor is not enabled,
then use the service processor
menus to enable the processor.
Then reboot the system.
2. If the processor is failing POST,
then replace the processor card
at the location specified in the
error log.
Location: U1.1-P1-C1
Remove the unknown processor
card.
Replace primary I/O backplane
Location: U0.1-P1
Replace primary I/O backplane
Location: U0.1-P1
If problem persists, replace primary
I/O backplane
Location: U0.1-P1
1. Replace the battery.
2. Replace primary I/O backplane
Location: U0.1-P1
Replace primary I/O backplane
Location: U0.1-P1
Replace memory card (s).
Replace memory card in slot 0.
Replace memory card in slot 1.
Advertisement
Table of Contents
