Table of Contents
Advertisement
Tape Drive
Removal
1. Turn off power as described in "Powering Off the System" on page 429.
2. If you have not already done so, open the front door of the rack unit.
3. Loosen the two thumbscrews that attach the front bezel to the I/O drawer.
4. Grasp both sides of the front bezel and pull it off the drawer.
5. Push up on the release lever and pull the tape drive out.
6. Disconnect the cables from the tape drive.
7. Remove the screws that connect the carrier to the tape drive.
Replacement
Replace in reverse order.
Chapter 9. Removal and Replacement Procedures
463
Advertisement
Table of Contents
