Table of Contents
Advertisement
v Read Service Processor Configuration
Displays current service processor configuration.
v Processor Configuration/Deconfiguration Menu
This menu allows the user to change the system processor configuration. If it is
necessary to take one of the processors offline, this menu allows you to deconfigure
a processor, and then reconfigure the processor at a later time. An example of this
menu is shown below:
PROCESSOR CONFIGURATION/DECONFIGURATION MENU
77. Enable/Disable CPU Repeat Gard: Currently Enabled
1. 0 3.0 (00) Configured by system
2. 2 3.1 (31) Deconfigured by system
3. 4 3.2 (00) Configured by system
4. 6 3.3 (00) Configured by system
98. Return to Previous Menu
1>
Note: This table is built from vital product data collected during the last boot
sequence. The first time the system is powered up, or after the system's
non-volatile RAM (NVRAM) has been erased, this table may be empty. The
table is rebuilt during the next boot into AIX.
The fields of the previous table represent the following:
Column 1
(1.) Menu selection index.
Column 2
(0) Logical processor device number assigned by AIX. You can
display these logical device numbers by issuing the following
command on the AIX command line:
lsdev -C | grep proc
Column 3
(3.0) Processor address list used by the service processor and
should be ignored.
Column 4
(00) Error status of the processors.
Chapter 7. Using the Service Processor
383
Advertisement
Table of Contents
