IBM 7026-H80 - RS/6000 - 256 MB RAM Service Manual page 278

Table 6. Service Processor Error Codes. (continued)
260
Service Guide
Error Code Description
406E 00A6 Scan control routine detected no
usable memory
406E 00A7 Scan control routine detected
hardware problem
406E 00B0 Scan control routine detected bus
controller lock-unlock failure
406E 00B1 Scan control routine detected bus
controller failure
406E 00B7 Scan control routines detected
insufficient hardware resources to
continue IPL
406E 0100 Scan control routine detected
memory riser card fault
406E 0101 Scan control routine detected
memory DIMM fault
406E 0102 Scan control routine detected
memory DIMM fault
406E 0103 Scan control routine detected
memory DIMM fault
406E 0104 Scan control routine detected
memory DIMM fault
406E 010D Scan control routine detected
memory DIMM fault
406E 0111 Scan control routine detected
memory DIMM fault
406E 0112 Scan control routine detected
memory DIMM fault
406E 0113 Scan control routine detected
memory DIMM fault
406E 0114 Scan control routine detected
memory DIMM fault
Action/
Possible Failing FRU
1. Ensure that memory DIMMs and
cards are properly installed.
2. Go to service processor memory
configuration/deconfiguration
menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 384 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 113.
Go to "MAP 1540: Minimum
Configuration" on page 113.
RIO adapter
Location: U0.1-P1.1
RIO adapter
Location: U0.1-P1.1
This error code appears after the
initial testing by the service processor
firmware on the CEC was completed
correctly, but a problem occurred
when the firmware tried to
communicate outside the CEC.
Suspect a problem with the RIO
interface, either cables or adapters.
Memory riser card
Location: U1.1-P1-M2
Memory DIMM
Location: U1.1-P1-M2.15
Memory DIMM
Location: U1.1-P1-M2.1
Memory DIMM
Location: U1.1-P1-M2.16
Memory DIMM
Location: U1.1-P1-M2.2
Memory DIMM
Location: U1.1-P1-M2.1 x4
Memory DIMM
Location: U1.1-P1-M2.13
Memory DIMM
Location: U1.1-P1-M2.3
Memory DIMM
Location: U1.1-P1-M2.14
Memory DIMM
Location: U1.1-P1-M2.4