Chapter 36
Configuring Switch Acceleration
Configuring Switch Acceleration on the Switch
By default, switch acceleration is disabled on the Supervisor Engine II. Before you enable switch
acceleration, you must disable the two front-panel Gigabit Ethernet uplink ports on Supervisor
Engine II.
Enabling Switch Acceleration
To enable switch acceleration, perform this task in privileged mode:
Task
Step 1
Disable front-panel Gigabit Ethernet ports. set port disable mod_num/port_num
Step 2
Enable switch acceleration.
This example shows how to enable switch acceleration on the switch:
Console> (enable) set port disable 1/1-2
Port(s) 1/1-2 disabled.
Console> (enable) set switchacceleration enable 1
Enabling or Disabling switch acceleration may impact performance for 1-2 seconds.
Do you want to continue (y/n) [n]? y
Switch Acceleration on module 1 enabled.
Console> (enable)
This example shows how to disable switch acceleration on the switch:
Console> (enable) set switchacceleration disable 1
Enabling or Disabling switch acceleration may impact performance for 1-2 seconds.
Do you want to continue (y/n) [n]? y
Switch Acceleration on module 1 disabled.
Console> (enable)
Displaying Switch-Acceleration Information
To display the switch-acceleration status, perform this task in privileged mode:
Task
Display the switch-acceleration status.
This example shows how to display the switch-acceleration status:
Console> show switchacceleration 1
Module 1 has switch acceleration enabled.
Console>
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Configuring Switch Acceleration on the Switch
Command
set switchacceleration {enable | disable} mod-num
Command
show switchacceleration mod_num
36-3