Configuring Poe; Migrating A Supervisor Engine Ii From A Catalyst 4006 Switch To A Catalyst 4500 Series Switch; Setting The Power Mode Of A Port Or Group Of Ports - Cisco WS-C2948G-GE-TX Configuration Manual

Configuring PoE

System Name
------------------------ ------------------------ ------------------------ ---
Switch#
Migrating a Supervisor Engine II from a Catalyst 4006 Switch to a Catalyst 4500
Series Switch
To migrate your supervisor engine from a Catalyst 4006 switch to a Catalyst 4503 or 4506 switch,
perform this task:
Task
Step 1
Change the nondefault configuration mode to
text and specify the configuration file to use at
boot up.
Step 2
Save the current nondefault configuration to
NVRAM.
Step 3
Save the configuration on the Catalyst 4006
switch.
Step 4 Remove the supervisor engine from the
Catalyst 4006 switch and insert it into the
Catalyst 4500 series switch.
Step 5
Clear the current configuration.
Step 6
Load the saved configuration.
Step 7
If you have only one power supply in your
Catalyst 4506 switch, set the power budget to 1.
If you have two power supplies, set the power
budget to 2.
Configuring PoE
These sections show how to configure PoE for the Catalyst 4500 series switches and the Catalyst 4006
switch.

Setting the Power Mode of a Port or Group of Ports

To set the power mode of a port or group of ports, perform this task in privileged mode:
Task
Set the power mode of a port or group of ports.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide
28-18
System Location
Command
set config mode text bootflash:switch.cfg
write memory
copy config flash
–
clear config all
configure bootflash:switch.cfg
set power budget 1
Command
set port inlinepower mod/port {[auto | static]
[max-wattage] | off}
Chapter 28
System Contact
Power Management
CC
—
Release 8.2GLX
78-15908-01