Setting The Back-End Authenticator-To-Host Frame-Retransmission Number; Resetting The 802.1X Configuration Parameters To The Default Values - Cisco WS-C2948G-GE-TX Configuration Manual

Chapter 31 Configuring 802.1x Authentication
To set the number of frames that are retransmitted from the back-end authenticator to the host, perform
this task in privileged mode:
Task
Set the back-end authenticator-to-host frame retransmission
number.
This example shows how to set the number of retransmitted frames that are sent from the back-end
authenticator to the host to 4:
console> (enable) set dot1x max-req 4
dot1x max-req count set to 4.
Console> (enable)

Setting the Back-End Authenticator-to-Host Frame-Retransmission Number

The authentication server notifies the back-end authenticator each time that it receives a specific number
of frames. When the back-end authenticator does not receive this notification after sending the frames,
the back-end authenticator waits a set period of time and then retransmits the frames. You may set the
number of frames that the back-end authenticator retransmits from 1–10 (the default is 2).
To set the number of frames that are retransmitted from the back-end authenticator to the host, perform
this task in privileged mode:
Task
Set the back-end authenticator-to-host frame retransmission
number.
This example shows how to set the number of retransmitted frames that are sent from the back-end
authenticator to the host to 4:
Console> (enable) set dot1x max-req 4
dot1x max-req set to 4.

Resetting the 802.1x Configuration Parameters to the Default Values

You can reset the 802.1x configuration parameters to the default values with a single command, which
also globally disables 802.1x.
To reset the 802.1x configuration parameters to the default values, perform this task in privileged mode:
Task
Step 1
Reset the 802.1x configuration parameters to the
default values and globally disable 802.1x.
Step 2
Verify the 802.1x configuration.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Configuring 802.1x Authentication on the Switch
Command
set dot1x max-req count
Command
set dot1x max-req count
Command
clear dot1x config
show dot1x
31-17