Chapter 19
Configuring Protocol Filtering
This example shows how to enable protocol filtering, set the protocol membership of ports, and verify
the configuration:
Console> (enable) set protocolfilter enable
Protocol filtering enabled on this switch.
Console> (enable) set port protocol 3/1-4 ip on
IP protocol set to on mode on ports 3/1-4.
Console> (enable) set port protocol 3/1-4 ipx off
IPX protocol disabled on ports 3/1-4.
Console> (enable) set port protocol 3/1-4 group auto
Group protocol set to auto mode on ports 3/1-4.
Console> (enable) show port protocol 3/1-4
Port
-------- ---------- -------- -------- -------- --------- -------- -----------
3/1
3/2
3/3
3/4
Console> (enable)
Disabling Protocol Filtering
To disable protocol filtering, perform this task in privileged mode:
Task
Disable protocol filtering.
This example shows how to disable protocol filtering:
Console> (enable) set protocolfilter disable
Protocol filtering disabled on this switch.
Console> (enable)
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Vlan
IP
IP Hosts IPX
4
on
1
5
on
1
2
on
1
4
on
1
Configuring Protocol Filtering on the Switch
IPX Hosts Group
off
0
auto-off 0
off
0
auto-on
off
0
auto-off 0
off
0
auto-on
Command
set protocolfilter disable
Group Hosts
1
1
19-3