Disabling Vtp Pruning; Displaying Vtp Statistics - Cisco WS-C2948G-GE-TX Configuration Manual

Configuring VTP Version 1 and Version 2
Port
--------
16/1
Port
--------
16/1
Console> (enable)

Disabling VTP Pruning

To disable VTP pruning, perform this task in privileged mode:
Task
Step 1 Disable VTP pruning in the management domain. set vtp pruning disable
Step 2 Verify that VTP pruning is disabled.
This example shows how to disable VTP pruning in the management domain:
Console> (enable) set vtp pruning disable
This command will disable the pruning function in the entire management domain.
Do you want to continue (y/n) [n]? y
VTP domain Lab_Network modified
Console> (enable)

Displaying VTP Statistics

To display VTP statistics, including the VTP advertisements that are sent and received and VTP errors,
perform this task:
Task
Display VTP statistics for the switch.
This example shows how to display VTP statistics on the switch:
Console> (enable) show vtp statistics
VTP statistics:
summary advts received
subset
request advts received
summary advts transmitted
subset
request advts transmitted
No of config revision errors
No of config digest errors
VTP pruning statistics:
Trunk
-------- ---------------- ------------- --------------------------- ----------
16/1
Console> (enable)
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
9-12
Vlans allowed and active in management domain
---------------------------------------------------------------------
Vlans in spanning tree forwarding state and not pruned
---------------------------------------------------------------------
advts received
advts transmitted
Join Transmitted Join Received Summary advts received from GVRP PDU
75 0
Command
show vtp domain
Command
show vtp statistics
0
0
0
7843
4
20
0
0
non-pruning-capable device
0
Chapter 9 Configuring VTP
Received
0
78-15908-01