Disabling Loop Guard - Cisco WS-C2948G-GE-TX Configuration Manual

Chapter 8 Configuring Spanning Tree PortFast, BPDU Guard, BPDU Filter, UplinkFast, BackboneFast, and Loop Guard
Do you want to continue (y/n) [n]? y
Loopguard on port 5/1 is enabled.
Console> (enable)
This example shows how to enable loop guard on all the ports on a switch:
Console> (enable) set spantree mst global-defaults loop-guard enable
Spantree global loop-guard state enabled on this switch.

Disabling Loop Guard

Enter the set spantree guard command to disable spanning tree loop guard on a per-port basis. To
disable loop guard on all the ports on a switch, use the set spantree mst global-defaults loop-guard
command.
To disable loop guard on the switch, perform this task in privileged mode:
Task
Step 1 Disable loop guard on a port.
Step 2 Verify that loop guard is disabled.
This example shows how to disable loop guard on port 5/1:
Console> (enable) set spantree guard none 5/1
Rootguard is disabled on port 5/1, disabling loopguard will disable rootguard on
this port.
Do you want to continue (y/n) [n]? y
Loopguard on port 5/1 is disabled.
Console> (enable)
This example shows how to disable loop guard on all the ports on a switch:
Console> (enable) set spantree mst global-defaults loop-guard disable
Spantree global loop-guard state disabled on this switch.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Command
set spantree guard {root | loop | none} mod/port
show spantree guard {mod/port | vlan} mistp-instance instance
Configuring Loop Guard
8-19