Cisco WS-C2948G-GE-TX Configuration Manual page 491

Chapter 30 Configuring Switch Access Using AAA
Task
Step 3 Disable authorization of configuration
commands. Enter the console or telnet keywords
if you want to disable the authorization only for
the console port or for the Telnet connection
attempts. Enter the both keyword to enable
authorization for both console port and Telnet
connection attempts.
Step 4
Verify the TACACS+ authorization configuration. show authorization
This example shows how to disable TACACS+ EXEC mode authorization for both console and Telnet
connections and how to verify the configuration:
Console> (enable) set authorization exec disable both
Successfully disabled enable authorization.
Console> (enable)
This example shows how to disable TACACS+ enable mode authorization for both console and Telnet
connections and how to verify the configuration:
Console> (enable) set authorization enable disable both
Successfully disabled enable authorization.
Console> (enable)
This example shows how to disable TACACS+ command authorization for both console and Telnet
connections and how to verify the configuration:
Console> (enable) set authorization commands disable both
Successfully disabled commands authorization.
Console> (enable)
This example shows how to verify the configuration:
Console> (enable) show authorization
Telnet:
-------
exec:
enable:
commands:
config:
all:
Console:
--------
exec:
enable:
commands:
config:
all:
Console> (enable)
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Primary Fallback
------- --------
tacacs+ deny
tacacs+ deny
tacacs+ deny
tacacs+ deny
Primary Fallback
------- --------
tacacs+ deny
tacacs+ deny
tacacs+ deny
tacacs+ deny
Command
set authorization commands disable [console |
telnet | both]
Configuring Authorization
30-45