Enabling Gvrp On Individual 802.1Q Trunk Ports - Cisco WS-C2948G-GE-TX Configuration Manual

Chapter 13 Configuring GVRP
To enable GVRP globally on the switch, perform this task in privileged mode:
Task
Step 1
Enable GVRP on the switch.
Step 2
Verify the configuration.
This example shows how to enable GVRP and verify the configuration:
Console> (enable) set gvrp enable
GVRP enabled
Console> (enable) show gvrp configuration
Global GVRP Configuration:
GVRP Feature is currently enabled on the switch.
GVRP dynamic VLAN creation is disabled.
GVRP Timers(milliseconds)
Join = 200
Leave = 600
LeaveAll = 10000
Port based GVRP Configuration:
Port
------------------------------------------------------- ----------- ------------
2/1-2,3/1-8,7/1-24,8/1-24
GVRP Participants running on 3/7-8.
Console>

Enabling GVRP on Individual 802.1Q Trunk Ports

You can change the per-trunk GVRP configuration regardless of whether GVRP is enabled globally.
Note
However, GVRP will not function on any ports until you enable it globally. For information on
configuring GVRP globally on the switch, see the
There are two per-port GVRP states:
•
•
You can configure the static GVRP port-state on any 802.1Q-capable switch ports, regardless of the
global GVRP enable state or whether the port is an 802.1Q trunk. However, in order for the port to
become an active GVRP participant, you must enable GVRP globally and the port must be an 802.1Q
trunk port, either through CLI configuration or Dynamic Trunking Protocol (DTP) negotiation.
To enable GVRP on individual 802.1Q-capable ports, perform this task in privileged mode:
Task
Step 1
Enable GVRP on an individual 802.1Q-capable port. set port gvrp enable mod_num/port_num
Step 2 Verify the configuration.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
The static GVRP state that is configured in the CLI and stored in NVRAM
The actual GVRP state of the ports (active GVRP participants)
Configuring GVRP on the Switch
Command
set gvrp enable
show gvrp configuration
GVRP Status Registration
Enabled
"Enabling GVRP Globally" section on page
Command
show gvrp configuration
Normal
13-2.
13-3