Configuring Portfast Bpdu Filtering; Enabling Portfast Bpdu Filtering - Cisco WS-C2948G-GE-TX Configuration Manual

Chapter 8 Configuring Spanning Tree PortFast, BPDU Guard, BPDU Filter, UplinkFast, BackboneFast, and Loop Guard
3
4
.
.
.
1003
1005
----- -------- --------- -------- ---------- ----------
Total
Console> (enable)

Configuring PortFast BPDU Filtering

The following sections describe how to configure PortFast BPDU filtering on the switch.

Enabling PortFast BPDU Filtering

Although you can configure PortFast on an individual port, you configure the PortFast BPDU filtering
Note
option globally. When you disable PortFast on a port, PortFast BPDU filtering becomes inactive for that
port.
To enable PortFast BPDU filtering, perform this task in privileged mode:
Task
Step 1
Enable BPDU filtering state on the port.
Step 2
Verify PortFast BPDU filtering setting.
For additional PVST+ information, see
Note
By default, BPDU filtering is set for each port. This example shows how to enable PortFast BPDU
filtering on the port and verify the configuration in PVST+ mode:
Console> (enable) set spantree portfast bpdu-filter 6/1 enable
Warning:Ports enabled with bpdu filter will not send BPDUs and drop all
received BPDUs. You may cause loops in the bridged network if you misuse
this feature.
Console> (enable) show spantree summary
Root switch for vlans: none.
Portfast bpdu-filter enabled for bridge.
Uplinkfast disabled for bridge.
Backbonefast disabled for bridge.
Vlan
----- -------- --------- -------- ---------- ----------
1
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
0 0
0 0
0 0
0 0
Blocking Listening Learning Forwarding STP Active
0 0
Blocking Listening Learning Forwarding STP Active
0 0
0 4 4
0 4 4
0 0 0
0 0 0
0 85 85
Command
set spantree portfast bpdu-filter mod/port
[disable | enable | default]
show spantree summary
Chapter 7, "Configuring Spanning Tree."
0 4 4
Configuring PortFast BPDU Filtering
8-13