Displaying Etherchannel Configuration Information - Cisco WS-C2948G-GE-TX Configuration Manual

Configuring EtherChannel Using PAgP
This example shows how to return a channel to its default configuration and how to verify the
configuration:
Console> (enable) set port channel 3/5-6 mode auto
Port(s) 3/5-6 channel mode set to auto.
Console> (enable) show port channel
No ports channelling
Console> (enable)

Displaying EtherChannel Configuration Information

To display EtherChannel configuration information, perform one of these tasks in privileged mode:
Task
Display EtherChannel configuration information
by port.
Display EtherChannel configuration information
by EtherChannel administrative group.
Display EtherChannel configuration information
by EtherChannel ID.
This example shows how to display EtherChannel configuration information by port:
Console> (enable) show port channel info
Switch Frame Distribution Method: mac both
Port
----- ---------- -------------------- ----- ------- ----- ------ ----
3/5
3/6
----- ---------- -------------------- ----- ------- ----- ------ ----
Port
----- ------- ---------- ---------- ----------------- -------------
3/5
3/6
----- ------- ---------- ---------- ----------------- -------------
Port
----- ------------------------------- ------------------------- ----------------
3/5
3/6
----- ------------------------------- ------------------------- ----------------
Port
----- ------------ ------------- -----------------------------------------------
3/5
3/6
----- ------------ ------------- -----------------------------------------------
Port
----- --------------------------------------------------------------------------
3/5
3/6
----- --------------------------------------------------------------------------
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
6-10
Status Channel
mode
connected on
connected on
ifIndex Oper-group Neighbor
Oper-group Method
377 1
377 1
Device-ID
069003103(5500)
069003103(5500)
Trunk-status Trunk-type
not-trunking negotiate
not-trunking negotiate
Portvlancost-vlans
Chapter 6 Configuring Fast EtherChannel and Gigabit EtherChannel
Command
show port channel [mod_num[/port_num]] info
[spantree | trunk | protocol | gmrp | gvrp | qos]
show channel group [admin_group] info
[spantree | trunk | protocol | gmrp | gvrp | qos]
show channel [channel_id] info [spantree | trunk
| protocol | gmrp | gvrp | qos]
Admin Channel Speed Duplex Vlan
group id
56 835 a-100 a-full
56 835 a-100 a-full
Oper-Distribution PortSecurity/
Dynamic port
mac both
mac both
Port-ID
3/5
3/6
Trunk-vlans
1-1005
1-1005
1
1
Platform
WS-C4000
WS-C4000
78-15908-01