Specifying The System Priority; Specifying The Port Priority; Specifying An Administrative Key Value - Cisco WS-C2948G-GE-TX Configuration Manual

Chapter 6 Configuring Fast EtherChannel and Gigabit EtherChannel

Specifying the System Priority

Note Although the set lacp-channel system-priority command is a global option, it applies only to modules
on which LACP is enabled; it is ignored on modules running PAgP.
The system priority value must be a number in the range of 1–65,535, where higher numbers represent
lower priority. The default priority is 32,768.
To specify the system priority, perform this task in privileged mode:
Task
Specify the system priority.
This example shows how to specify the system priority as 20,000:
Console> (enable) set lacp-channel system-priority 20000
LACP system priority is set to 20000
Console> (enable)
Use the show lacp-channel sys-id command to display the LACP system ID and system priority.

Specifying the Port Priority

The port priority value must be a number in the range of 1–255, where higher numbers represent lower
priority. The default priority is 128.
To specify the port priority, perform this task in privileged mode:
Task
Specify the port priority.
This example shows how to specify the port priority as 10 for ports 1/1 to 1/4 and 2/6 to 2/8:
Console> (enable) set port lacp-channel 1/1-4,2/6-8 port-priority 10
Port(s) 1/1-4,2/6-8 port-priority set to 10.
Console> (enable)
Use the show lacp-channel group admin_key info command to display the port priority.

Specifying an Administrative Key Value

Note When the system or module configuration information that is stored in NVRAM is cleared, the
administrative keys are assigned new values automatically. For modules, each group of four consecutive
ports, beginning at the 1st, 5th, 9th and so on, are assigned a unique administrative key. Across the
module, ports must have unique administrative keys. After NVRAM is cleared, the channel mode of the
ports is set to "passive."
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Command
set lacp-channel system-priority value
Command
set port lacp-channel mod/ports port-priority value
Configuring EtherChannel Using LACP
6-19