Displaying System Information - Cisco WS-C2948G-GE-TX Configuration Manual

Chapter 28 Power Management
This example shows how to set the power budget to 1 (1+1 redundancy mode) and verify the power
budget and current power usage for the switch:
Console> (enable) set power budget 1
Warning:
Your power supply budget will be constrained to
the power available from only one power supply.
Do you want to continue? [confirm (y/n)]:y
Console> (enable) show environment power
Total Inline Power Available:0 Watt
Total Inline Power Drawn From the System:0 Watt
Remaining Inline Power in the System:0 Watt
Default Inline Power allocation per port:6.00 Watts (0.11 Amps @51V)
Module
------
1
2
3
Power Budget is :2 supplies
Power Available to the System (excluding voice power):750 Watts (62.06 Amps
@12V)
Power Drawn from the System (excluding voice power):265 Watts (22.01 Amps
@12V)
Remaining Power (excluding voice power):485 Watts (40.05 Amps @12V)
Console> (enable)

Displaying System Information

To display information about the power supplies that are installed in the chassis and about the chassis,
perform this task:
Task
Display system information.
This example shows how to display the output for the show system command with mixed power
supplies:
Switch# show system
PS1-Status PS2-Status
---------- ----------
ok
Fan-Status Temp-Alarm Sys-Status Uptime d,h:m:s Logout
---------- ---------- ---------- -------------- ---------
ok
PS1-Type
----------------- -----------------
PWR-C45-2800AC
Modem
------- ----- ------- ---- -------------------------
disable
Power Capacity of the Chassis: 1 supply
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide
78-15908-01
Inline Power Allocated(mA)
--------------------------
0
0
0
err-disable
off ok
PS2-Type
PWR-C45-1000AC
Baud Traffic Peak Peak-Time
9600 0% 0% Fri May 31 2002, 10:24:04
Command
show system
74,23:42:50 20 min
Configuring Power Management
—
Release 8.2GLX
28-17